Accounting for T-Type rear derailleur mounting.Offset rear dropouts for fatbike tire clearance.Selecting dropouts from static drawings.Motor cabinet for Shimano E6000 series STEPS system.Locating water bottle bosses from either end of the tube.Single sided yokes applied to both drive and non-drive side.Locating cable guides from either end of tube.Cable guides and holes for internal cable routing.Bridges (modeling chain stay and seat stay bridges for locating caliper brakes).Designing a frame to suit predefined lug angles.Mitering the seat tube to the down tube or chain stays.Offsetting seat tube, down tube, or chain stays at the bottom bracket.Alternate method for specifying curved tubes. ![]() Identifying problematic curves in BikeCAD Pro.Extension of head tube and seat tube above top tube and below down tube.Discontinuous seat tube option for beam bike design.Attaching seat stays to seat tube, but measuring from top tube.Driving frame geometry by rear axle to seat tube.Controlling the rear end by chain stay length or by rear wheel gap.Establishing saddle position by saddle height and seat angle or by X and Y coordinates.Defining front end geometry in 6 different ways.Defining front end geometry through front center, effective top tube length, handlebar position or stack and reach.Dimensions helpful for mitering to tapered head tubes.Steering geometry related dimension from ISO 4210-2: Annex A, b).Creating angular dimensions with respect to horizontal.Snapshot tool (must be enabled as described here).Morph one model into another and save as animated GIF.Wheel display can be toggled through 4 levels of detail. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |