![]() Added option set the speed of printing Wipe Wall and Wipe Tower.Ģ6. Added option to limit the length of travel path while traveling around the holes.Ģ5. Added option to enable retraction at defined top and bottom layers even Avoid Retraction Inside Models is enabled.Ģ4. Added option to force retraction before moving to outer shell.Ģ3. Added option to override filament settings for the right extruder only.Ģ2. What’s more, you can choose to heat up the inactive extruder to some temperature in advance to reduce the waiting time.Ģ1. ![]() The nozzles will move to the park position to wait until the next printing nozzle reaches to the target temperature. ![]() Added option to cool down inactive extruder.Ĭool down the inactive extruder during printing to prevent oozing. Added option to blip fan speed to 100% when starting from a low fan speed.Ģ0. The printing speed will be reduced to increase the layer printing time and the fan speed but not exceed the maximum fan speed.ġ9. If the current layer printing time is shorter than the defined minimal layer print time, you can opt to enable printing speed and fan speed auto-tuning. Added option to drop the printing speed and increase fan speed for the layers with shorter layer printing time compared with minimal layer print time. Added option to print outer shell first after Brim for the first layer.ġ8. Added more settings under Raft – Raft Infill Angle, and Raft Flow Rate.ġ7. Added option to unify the infill structures for multiple isolated models.Įvery infill structure will be aligned to same origin and offset for multiple isolated models.ġ6. Added option to define infill patterns for top and bottom solid parts separately.ġ5. With this option enabled, the software will use gap filling to fill the narrow sections.ġ4. The narrow solid sections sometimes will be failed to be fully filled with the selected solid fill pattern. Added option to fill the solid parts with gap filling if the parts are failed to be filled by Lines, Rectilinear or Concentric pattern. Multiple layers of infill will be merged and printed once each several layers. Added option to print infill once each several layers. Added option to set interlaced infill angle for infill structure and solid fill parts.ġ2. You can set the distance of the travel path and the traveling speed.ġ1. Added option to wipe the nozzles at the end of loop of the outer shell.Īdding an extra travel path at the end of the outer shell is helpful to reduce Z-seam scars. Added option to place coasting on Grid Pattern Infill and Lines Pattern Solid Fill.ġ0. Added option to only enable Z Hop when printing solid fill sections.Įnabling this option will trigger Z Hop only at the top or bottom solid layers which will reduce quantity of Z Hop and avoid the effects of nozzle traveling above the printed solid sections which can help leave a cleaner solid surface.ĩ. Added option to print infill structure before shells.Ĩ. Negative value will decrease the size of contours and holes of objects in each layer.ħ. You can set different compensation values for contours and holes. Added option to set XY compensation for outer contours and holes. Added option to merge the two nearby lines to be one.Ħ. Added option to set the minimal length of each single extrusion line.ĥ. ![]() Avoid placing the start point at overhang sections in each layer.Ĥ. If the angel of two edge lines at corner is larger than 180 degrees, the corner is a reflex corner. You can choose to place the start points at the reflex or convex corner of the outer shell. Added seam hiding options to place the start point on the corner. Added option to print shells in optimal order to reduce travel moves.įor example, before moving from one hole to another, the shells of one hole will be completed first instead of printing all the outer shells of all holes first then start printing inner shells.Ģ. New requested features and debugging based on user feedback.ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |